AL-601-00-868 Door sign 15×15 RGB FLEX / EnoSign
Illuminated door sign RGB, EnOcean, 15x15cm, +24V DC
The illumintaed door sign
AL-601-10-868 Door sign 15×15 RGB FLEX / EnoSign
has an integrated EnOcean wireless transceiver, and allows to control color and dimlevel of the EnoSign, made of 10mm opal white Plexiglas®.
The EnoSign has the following main features:
- Supply voltage: +24 V DC
- 1x EnOcean transceiver, bi-directional
- Illuminated by RGB-LEDs, dimlevel of each color can be setup from 0..254 (0..100%)
- Aluminium profile
- Plastic frame for on-wall mounting
The configuration of the EnoSign can easily be changed using the PC software BL-PC-FLEX-2 and an EnOcean USB stick..
Color and dimlevel can be controlled by an EnOcean light switch in case of small installations in a doctors room, for example.
In other cases, if there is a room reservation system installed with a software interface to a calendar, color of the EnoSign can be changed by a control system.
Also a motion detector can be used to control directly the color and the dimlevel of the device. When motion is detected in the room, light is switched to red. Once no motion is detected any longer, the EnoSign will switch to green light after a configurable time delay.
The only wired connection of the EnoSign is the power supply of +24 V DC.
To mount the EnoSign on a wall, the plastic frame is mounted with to screws only.
Wireless configuration with EnOcean USB stick and PC software BL-PC-FLEX-2
You can easily setup the EnoSign to be controlled by EnOcean telegrams like RPS with the easy to use PC software tool BL-PC-FLEX-2.
interfaces
Only two interfaces:
1. Wireless control by EnOcean
2. Power supply with 24V DC
colors
Each of the colors red, green and blue can be dimmed in 256 steps. In this way, up to 16 Mio. colors are possible.
options
Since you can configure the EnoSign at any time with the PC tool BL-PC-FLEX-2, and you can easily attach Symbols, numbers or characters to the plate, you can think of numerous applications for the EnoSign.
Control by light switch (RPS), motion detector or a control system (for example using EnoDisc)
As an example, the EnoSign can be controlled by an EnOcean light switch inside a room, to signal that the customer standing outside should wait, or that he is allowed to enter into the room.
Another use case is to control the EnoSign from the cloud, to signal if a meeting room is free or reserved. EnOcean messages to control the color and the dimlvel can be send by an EnoDisc.
Easy installation and setup
The EnoSign is supplied by a two-wire interface with 24V DC. Since the communication is done by EnOcean, no communication line is necessary. In this way, the effort for installation and maintenance is reduced to a minimum level.
The EnoSign can be easily mounted to a wall with two countersunk screws.